Dec 2026
PhD Advisor: Professor Rod Wing
Abstract:
CO2 enrichment raises greenhouse yield, but the standard method, injecting
CO2 gas, needs a closed greenhouse. In hot climates, greenhouses must be
ventilated and cooled, so the gas is lost to the outside. CO2-misting is an
alternative: water is infused with CO2 and sprayed onto the crop as a mist.
Evidence so far is mostly commercial. This thesis assesses it in three steps.
Chapter 2 asked whether plants can fix CO2 from the CO2-rich droplets. Water
labelled with 13C was applied to the leaves of lettuce, tomato, and cucumber.
The label appeared in plant tissue and in sugars and organic acids, and uptake
increased with the dissolved CO2 concentration. In greenhouse trials, lettuce
yield also increased with concentration, and the mist with the highest CO2
concentration raised yield by 15 to 29% compared with water-only mist.
Chapter 3 compared CO2-misting with CO2-gassing and no enrichment. CO2
misting increased fresh yield by 11 to 13% and dry weight by 11 to 15%, about
half of the gain from CO2-gassing (21 to 24%), without enriching the
greenhouse air. As complete systems, CO2-misting with evaporative cooling
produced 11% less yield than CO2-gassing with air conditioning, but used 39%
less energy and half the CO2, and its operating resource cost was 65% of that
of CO2-gassing. It used three times more net water, mainly because of
evaporative cooling.
Chapter 4 asked where the CO2 is lost between the tank and the leaf and
proposed ways to maximize its concentration throughout the system. Cooling
the tank water raised the dissolved CO2 concentration, but from the tank
onward CO2 was lost at every stage: 17% of the tank concentration was lost in
the delivery line, and on average only about 5% remained 120 cm below the
nozzle. Most of the loss occurred as the droplets formed, within the first 10 cm
after the nozzle. Nozzles with larger droplets retained two to three times more
dissolved CO2, and a two-stage physical model reproduced this effect of
droplet size.
Together, the results show that plants use CO2 delivered in water, and that
CO2-misting can raise yield with less energy and CO2 than gassing, but a lot
of the dissolved CO2 is lost before it reaches the leaf. A cold, well-sealed tank,
a short and cool delivery line, and nozzles with larger droplets placed close to
the canopy should reduce this loss.
Bio:
PhD student in Environmental science and engineering, MSc in plant science from KAUST and BSc in Agriculture from AUB. Specialized in greenhouse production and optimization.